CRS2F3111-100 Transition Networks Point System RS232 Copper to Fiber Media Converter

Transition Networks' serial RS232 to Fiber Media Converter allows you to extend the distance between serial connections with the use of fiber optic cable. This full-featured converter transmits the full complement of RS232 flow control/handshaking signals optically and supports full or half-duplex asynchronous data transmission at speeds up to 115Kb/s.

The diagnostic features included on this converter make installation easy and intuitive. A DTE/DCE switch eliminates the frustration over selecting the appropriate cable. A loop-back switch allows for complete diagnostic testing prior to system turn-up or during troubleshooting. Unit and Port LEDs allow for quick status information of the converter.

General Information
Manufacturer	Transition Networks, Inc
Manufacturer Part Number	CRS2F3111-100
Manufacturer Website Address	http://www.transition.com
Brand Name	Transition Networks
Product Line	Point System
Product Model	CRS2F3111-100
Product Name	Point System RS232 Copper to Fiber Media Converter
Product Type	Transceiver/Media Converter
Interfaces/Ports
Total Number of Ports	2
Number of ST Ports	1
ST Port Type	Duplex
Number of Serial Ports	1
Media & Performance
Media Type Supported	Optical Fiber
Fiber Mode Supported	Multi-mode
Maximum Distance Supported	2 km
Power Description
Power Consumption	5 W
Physical Characteristics
Form Factor	Internal
Height	3.4"
Width	3.4"
Depth	5"
Miscellaneous
Additional Information	Switches: DTE/DCE Loop-back Loopback (Local or Remote on copper and fiber) Supports the following flow control signaling: DCD - Data Carrier Detect RXD - Receive Data TXD - Transmit Data DTR - Data Terminal Ready SG - Signal Ground DSR - Data Set Ready RTS - Request To Send CTS - Clear To Send
Compatibility	Pointy System Chassis
Certifications & Standards	EIA/TIA-574 EIA/TIA RS-232E Compliance: CISPR22/EN55022 Class A + EN55024 EN60950 Class A FCC Class A CE Mark
Country of Origin	United States
Warranty
Limited Warranty	Lifetime

•  Media converter
•  serial RS-232
•  9 pin D-Sub (DB-9)
•  ST multi-mode
•  plug-in module
•  up to 1 miles
•  1300 nm


Transition Networks' serial RS232 to Fiber Media Converter allows you to extend the distance between serial connections with the use of fiber optic cable. This full-featured converter transmits the full complement of RS232 flow control/handshaking signals optically and supports full or half-duplex data transmission at speeds up to 128Kb/s.

The diagnostic features included on this converter make installation easy and intuitive. A DTE/DCE switch eliminates the frustration over selecting the appropriate cable. A loop-back switch allows for complete diagnostic testing prior to system turn-up or during troubleshooting. Unit and Port LEDs allow for quick status information of the converter.

Download DataSheet