Moxa Mfg Mini-Store MOXA Major Lines
Moxa ioLogik E2242 Active Ethernet I/O with 4 analog inputs and 12 configurable DIOs
MOXA Major LinesMfg Part Number: ioLogik E2242 , Item #: 879933
In Stock: 5
, PO and Wire.
Better I/O matrix for monitoring
Moxa's ioLogik E2242 is tailor made for use with remote monitoring and alarm systems. This Active Ethernet I/O product provides 4 analog inputs and 12 configurable DIOs in the same product. The 1:3 ratio of analog to digital IOs is perfectly adapted for water tank monitoring and environmental monitoring applications, in which 1 analog input is used to trigger 3 digital outputs as High-High, High, and Low alarms. Moxa's ioLogik E2242 lets you set up your monitoring system without the need for a local PC or RTU.
Features and Benefits
- 4 fixed differential analog input channels
- 12 configurable digital input/output channels
- Instant event messaging by TCP, UDP, e-mail, SNMP Trap
- PC-based configuration utility and web console
- Easy-to-use Click&Go™ Logic for local output control
- I/O control over Modbus/TCP and SNMP protocol
- NIST traceable calibration
| LAN: | |
| Ethernet | 10/100Mbps, RJ45 |
| Protection | 1.5KV magnetic isolation |
| Protocols | Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, SNMP(MIB for I/O and Network), HTTP, SNTP |
| Serial: | |
| Interface | RS-485-2w: Data+, Data-, GND |
| Serial Line Protection | 15KV ESD for all signals |
| Serial Communication Parameters: | |
| Data Bits | 8 |
| Stop Bits | 1 |
| Parity | None |
| Flow Control | None |
| Protocols | Modbus/RTU |
| Speed | 1200 to 115200 bps |
| Digital Input: | |
| Sensor Type | NPN, PNP |
| I/O Mode | DI or event counter (up to 900 Hz) |
| Dry Contact | Logic 0: short to
GND Logic 0: Open |
| Wet Contact | Logic 0: 0 to 3 VDC Logic 1: 10 to 30 VDC |
| Common Type | 6 points per COM |
| Power Off Storage for Counter Mode | Yes |
| Digital Output: | |
| Sensor Type | Sink, 36 VDC, 200 mA |
| Pulse Wave Width | 10 ms /100 Hz |
| Configurable Digital Input/Output Channels: | |
| Channels | 12 points |
| Analog Input: | |
| Resolution | 16-bit |
| Accuracy | ±0.1% FSR @ 25?C, ±0.3% FSR @ -10 and 60?C |
| Sampling Rate (all channels) | 100 samples/sec |
| Input Impedence | 200K ohms (min.) |
| Built-in Resistor for Current Input | 102 ohms |
| Channels | 4, differential input |
| Physical Characteristics: | |
| Wiring | I/O cable max. 14AWG |
| Environmental Limits: | |
| Operating Temperature | -10 to 60°C (14 to 140°F) |
| Storage Temperature | -40 to 85°C (-40 to 185°F) |
| Ambient Relative Humidity | 5 to 95% (non-condensing) |
| Power Requirements: | |
| Power Input | 24 VDC nominal, 12 to 48 VDC |
| DO Power | 24 VDC nominal, up to 30 VDC |
| Agency Approvals: | |
| EMI | FCC Part 15, CISPR (EN55022) class A |
| EMS | IEC 61000-4, IEC 61000-6 |
| Safety | UL508 |
| Shock | IEC 60068-2-27 |
| Freefall | IEC 60068-2-32 |
| Vibration | IEC 60068-2-6 |
Specification
| Power Requirements | |
| Power Consumption | 178 mA @ 24 VDC |
| Power Input | 24 VDC nominal, 12 to 36 VDC |
| Serial Communication Parameters | |
| Flow Control | None |
| Protocol | Modbus/RTU |
| Data Bits | 8 |
| Parity | None |
| Stop Bits | 1 |
| Baudrate | 1200 to 115200 bps |
| Analog Input | |
| Type | Differential input |
| Input Impedance | 200K ohms (min.) |
| Built-in Resistor for Current Input | 120 ohms |
| Resolution | 16 bits |
| Input Range | ±150 mV, 0 to 150 mV, ±500 V, 0 to 500 mV, ±5 V, 0 to 5 V, ±10 V, 0 to 10 V, 0 to 20 mA, 4 to 20 mA |
| Sampling Rate (all channels) | 100 samples/sec |
| Accuracy | ±0.1% FSR @ 25°C ±0.3% FSR @ -10 and 60°C |
| I/O Mode | Voltage / Current |
| Inputs and Outputs | |
| Analog Inputs | 4 channels |
| Configurable DIOs | 12 channels |
| LAN | |
| Protection | 1.5 KV magnetic isolation |
| Ethernet | 1 x 10/100 Mbps, RJ45 |
| Protocols | Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, SNMP, HTTP, CGI, SNTP |
| Digital Input | |
| Isolation | 3K VDC or 2K Vrms |
| Poweroff Counter | Supports poweroff counter storage function |
| Common Type | 6 points per COM |
| Over-voltage Protection | 36 VDC |
| Digital Filtering Time Interval | Software selectable |
| Dry Contact | • On: short to GND • Off: Open |
| Wet Contact | • On: 0 to 3 VDC • Off: 10 to 30 VDC |
| Counter Frequency | 900 Hz, power off storage |
| I/O Mode | DI or event counter |
| Sensor Type | Wet Contact (NPN or PNP) and Dry Contact |
| Environmental Limits | |
| Operating Temperature | -10 to 60°C (14 to 140°F) |
| Storage Temperature | -40 to 85°C (-40 to 185°F) |
| Ambient Relative Humidity | 5 to 95% (non-condensing) |
| Physical Characteristics | |
| Weight | under 250 g |
| Dimensions | 115 x 79 x 45.6 mm (4.53 x 3.11 x 1.80 in) |
| Wiring | I/O cable max. 14 AWG |
| Standards and Certifications | |
| EMI | FCC Part 15 Subpart B Class A, EN 55022 Class A |
| Safety | UL 508 |
| Shock | IEC 60068-2-27 |
| Vibration | IEC 60068-2-6 |
| EMS | IEC 61000-4, IEC 61000-6 |
| Freefall | IEC 60068-2-32 |
| Digital Output | |
| Type | Sink |
| Isolation | 2K Vrms or 3K VDC (Magnetic) |
| Pulse Output Frequency | 1 kHz |
| Over-temperature Shutdown | 175°C (min.) |
| Over-voltage Protection | 45 VDC |
| Current Rating | 200 mA per channel |
| I/O Mode | DO or Pulse Output |
| Over-current Protection | 2.6 A (4 channels @ 650 mA) |
| Serial Communication | |
| Interface | RS-485-2w: Data+, Data-, GND |
| Serial Line Protection | 15 KV ESD for all signals |
| MTBF (mean time between failure) | |
| Time | 204,391 hrs |
| Database | Telcordia (Bellcore) |
| Warranty | |
| Warranty Period | 5 years |
| Details | See www.moxa.com/warranty |
WARNING:: The plastic used in cable products can expose you to lead and lead components,
chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
For more information go to www.P65Warnings.ca.gov
Manufacturer Warranty Policy:
MOXA
Moxa products are warranted to be free from manufacturing defects in materials and workmanship starting from the date of delivery. The actual warranty period of the product(s) depends on the product category.
Warranty Periods
- Warranty Period Products Category
- 5 Years Embedded RISC Box Computers
- 3 Years Embedded x86 Box Computers
- 2 Years Ethernet I/O Products
- 5 Years Industrial Ethernet Switches
- 5 Years Media Converters
- 5 Years Serial to Ethernet Products
- 5 Years USB to Serial Hubs
- 5 Years Video over IP Servers
- 5 Years Wireless Ethernet Products
* The 3-year warranty period for Embedded x86 Box Computers is effective for products shipped after Jan. 1, 2010. A 5-year warranty still applies to products shipped before 2010.
* For products containing storage devices (hard drives, flash drives, etc.), back up your data before sending the products for repair. Moxa is not responsible for any loss of data. Please ensure the use of properly licensed software with our systems. Moxa does not condone the use of pirated software and will not service systems using such software. Moxa will not be held legally responsible for products shipped with unlicensed software installed by the user.
* If the customer opens the computer to install an HDD without making any modifications to the unit, the warranty will remain valid.
- Warranty Period Accessories
- 3 Years SFP Ethernet Modules
- 3 Years DIN-Rail Power Supplies
- 1 Years Power Adaptors
- 1 Years Fiber Patch Cords, SC to ST Duplex Adaptors
- 5 Years Serial Connection Boxes
- 5 Years Serial Connection Cables
- Oiginal manufacturers' warranty period. Hard Drives
Product warranties remain valid provided the product was properly installed and used. Defects, malfunctions, or failures of the warranted product caused by damage resulting from acts of God (such as floods, fire, etc.), environmental and atmospheric disturbances, other external forces such as power line disturbances, host computer malfunction, plugging the board in under power, or incorrect cabling, and damage caused by misuse, abuse, and unauthorized alteration or repair, are not warranted. A product will not be warranted in the following situations:
- The product has been found to be defective after the warranty period has expired.
- The product has been subjected to misuse, abuse, or unauthorized repair, whether by accident or other cause. Such conditions will be determined by Moxa at its sole and unfettered discretion.
- The warranty for customized and ODM products is defined by contract, and is excluded from this policy.
- The product is an accessory not carrying the Moxa brand name. In this case, warranties are limited to the warranty provided by the original manufacturer of the accessory. Examples of such products and accessories are power adaptors and cables.
- The product has been updated, reworked, or improperly tested by the customer, or by a third party at the request of the customer.
- The product is damaged beyond repair due to natural disasters, such as by lightning, flood, earthquake, etc.
- The product in question is either software, or an expendable item, such as a fuse, battery, SD/ CF card, RAM/ DOM module, etc.
- Products with altered and/or damaged serial numbers are not entitled to ourwill not be serviced by Moxa.
This warranty is limited to the repair and/or replacement, at Moxa's sole discretion, of the defective product during its warranty period. Moxa will replace any product found to be defective within the first three months of purchase provided said product was properly installed and used. The customer must obtain a Return Merchandise Authorization (RMA) number prior to returning the defective product to Moxa for service.
The customer agrees to insure the product or assume the risk of loss or damage during transit, to prepay shipping charges, and to use the original shipping container or equivalent. Customers may either seek assistance from the original dealer, or from the closest Moxa Service Office. Repaired or replaced products are warranted for ninety (90) days from the date of repair or replacement, or for the remainder of the original product's warranty period, whichever is longer. For large order projects, customers may purchase an extended maintenance contract. Such products may have a shorter chipset life cycle, or some parts may have a limited warranty from the original supplier of the parts. Please contact Moxa's sales department if you would like to extend the maintenance period of a Moxa product.
Limitation of Liability
The provisions of the warranty are in lieu of any other warranty, whether expressed or implied, written or oral. Moxa's liability arising out of the manufacture, sale, or supplying of the product and its use, whether based on warranty, contract, negligence, product liability, or otherwise, shall not exceed the original cost of the product. In no event shall Moxa be liable for unintended or consequential damages, including, but not limited to, a loss of profits or use damages arising out of the manufacture, sale, or supplying of the product.
