Tripp Lite's SMART700HG medical-grade UPS system provides dependable battery backup and is fully compliant with UL 60601-1 regulations when plugged into a hospital-grade outlet, making it ideal for use in patient-care vicinities. The 700VA/450W capacity provides up to 42 minutes of runtime for a half load, or 18 minutes for a full load so you can work through short power failures and perform an orderly system shutdown in a prolonged blackout. Built-in line-interactive voltage regulation corrects brownouts as low as 81V and overvoltages as high as 143V to normal 120V nominal output, without drawing battery power. The SMART700HG's built-in isolation transformer with Faraday shield offers full isolation and removes common mode noise while maintaining full AC surge suppression in all modes. This UPS system features four NEMA 5-15R-HG hospital-grade outlets and has a hospital-grade NEMA 5-15P-HG plug with a 6 ft. cord for flexibility in placement. All four outlets provide both backup protection and surge protection, rated to 480 joules. The SMART700HG also features diagnostic LEDs, as well as a USB port and a DB9 serial port that work with Tripp Lite's free downloadable PowerAlert software for safe, unattended system shutdown and file saves in the event of a prolonged power failure.
Application Usage
This UPS contains a lead acid battery designed to be connected continuously to an AC power source, except during brief power outages. It is not intended for frequent charge/discharge cycles, such as mobile cart applications where the UPS is often disconnected from the power source. Using the SMART700HG in this type of application will void the battery warranty. For mobile applications, Tripp Lite recommends the SMART700HGL with lithium iron phosphate (LiFePo4) battery.
General Information | |
Manufacturer | Eaton Corporation |
Manufacturer Part Number | SMART700HG |
Manufacturer Website Address | http://www.eaton.com |
Brand Name | Tripp Lite by Eaton |
Product Line | SmartPro |
Product Name | SmartPro 700HG UPS |
Product Type | Line-interactive UPS |
Technical Information | |
Plug/Connector Type | NEMA 5-15P |
Receptacle Type | NEMA 5-15R |
Receptacle Detail | 4 x NEMA 5-15R |
Cord Length | 6 ft |
Transfer Time | 4 ms |
Power Description | |
Load Capacity (VA) | 700 VA |
Load Capacity (Watt) | 450 W |
Input Voltage | 120 V AC |
Output Voltage | 120 V AC |
Management | |
Network Management | SNMP Manageable |
Alarm | Low Battery |
Alarm | On Battery |
Alarm | Overload |
Controls/Indicators | |
Status Indicators | 5 front-panel indicator LEDs to show battery charge level, AC line voltage levels, automatic voltage regulation status, UPS load level and replace battery warning |
Interfaces/Ports | |
USB | Yes |
Battery Information | |
Battery Chemistry | Lead Acid |
Backup/Run Time (Full Load) | 18 Minute |
Backup/Run Time (Half Load) | 42 Minute |
Battery Life | 6 Year |
Typical Battery Recharge Time | 4 Hour |
Hot Swappable | Yes |
Environmental Conditions | |
Maximum Operating Temperature | 104°F (40°C) |
Physical Characteristics | |
Height | 12.5" |
Width | 7" |
Depth | 9" |
Form Factor | Tower |
Weight (Approximate) | 44 lb |
Miscellaneous | |
Package Contents |
|
Additional Information |
|
Certifications & Standards | UL1778 (USA, Series AGSM700PSR3HG), UL2601-1 (Medical), cUL (Canada), FCC Class A (emissions), Conforms to IEEE 587 / ANSI C62.41 specifications |
Country of Origin | China |
Warranty | |
Limited Warranty | 2 Year |
General Information | |
Power Rating | 700 VA |
Output Voltage Rating | 120 V |
Number of Outputs | 4 |
Runtime-Full Load | 18 min |
Runtime-Half Load | 42 min |
Tripp Lite's SMART 700HG offers medical-grade UPS protection with
built-in line interactive voltage regulation, intelligent monitoring
and unattended shutdown capability. UL 60601-1 listed as medical
electrical equipment with less than 300 microamps leakage current for
the UPS and all connected equipment. Built-in isolation transformer
with faraday shield removes common mode noise while maintaining full AC
surge suppression in all modes. Resistant to electrostatic discharge.
Includes high quality hospital-grade plug and outlets. 700VA power
handling capacity supports computers, internetworking equipment and
other critical loads during commercial power failures. Line interactive
voltage regulation corrects brownouts as low as 81V and overvoltages as
high as 143 back to normal 120V levels, saving battery reserves for use
only during complete power failures. Includes 4 outlets, diagnostic
LEDs and built-in USB & RS-232 communications ports that work with
downloadable PowerAlert Software and cabling to provide automatic
unattended shutdown of connected network and PC applications.
Features:
SYSTEM OVERVIEW | |
System overview:
|
Medical Grade tower line interactive UPS system
includes built in isolation transformer with faraday shield and line
interactive voltage regulation, AC surge suppression, RS-232 and USB
monitoring ports with complete cabling, plus hospital-grade plug and
outlets. UL2601-1 listed as medical electrical equipment with less than
300 microamps cumulative leakage current for UPS and connected loads.
|
Voltage compatibility:
|
120V AC
|
Frequency compatibility:
|
60 Hz
|
OUTPUT | |
Output volt amp capacity (VA):
|
700
|
Output watt capacity (watts):
|
450
|
Output nominal voltage:
|
120V AC
|
Output voltage regulation:
|
LINE MODE: Sine wave line voltage 120V (-18% /
+8%)
BATTERY MODE: PWM sine wave output 120V +/-5% |
Output frequency regulation:
|
LINE MODE: Passes line frequency of 60Hz +/-10%
BATTERY MODE: Inverter output regulated to 60Hz +/-0.5Hz |
Outlet quantity / type:
|
4 NEMA 5-15R HG
|
Overload protection:
|
Resettable circuit breaker
|
INPUT | |
Maximum input amps:
|
5.5A / 550 watts
|
Input connection type:
|
NEMA 5-15P HG
|
Input cord length:
|
6 ft., 14 gauge
|
Recommended electrical service:
|
15A 120V
|
BATTERY | |
Full load runtime:
|
18 minutes (700VA)
|
Half load runtime:
|
42 minutes (350VA)
|
DC system voltage:
|
36V DC
|
Typical battery lifespan:
|
3-6 years, depending on usage
|
Battery recharge rate:
|
2-4 hours to 90%
|
VOLTAGE REGULATION | |
Voltage regulation description:
|
Line interactive UPS offers 2 boost levels of
brownout correction and a single level of overvoltage adjustment to
maintain usable, computer grade output without consuming battery power
over an input voltage range of 81 to 143V AC.
|
Overvoltage correction:
|
Input voltages between 126 and 143V AC are
reduced by 9%
|
Direct pass through:
|
Input voltages between 105 and 125V AC are
passed through unchanged
|
Brownout correction:
|
Input voltages between 96 and 106V AC are
boosted by 10%
|
Severe brownout correction:
|
Input voltages between 81 and 95V AC are
boosted by 21%
|
LEDS ALARMS & SWITCHES | |
Front panel LEDs:
|
Yes, includes 5 front-panel indicator LEDs to
show battery charge level, AC line voltage levels, automatic voltage
regulation status, UPS load level and replace battery warning
|
Alarms:
|
3 function audible alarm indicates power
failure conditions (4 short beeps every 10 seconds), overload
(continuous short beeps) and low battery (continuous tone)
|
Switches:
|
Yes, includes 2 front panel mounted push-button
switches for system enable, self-test and alarm cancel functions
|
SURGE / NOISE SUPPRESSION | |
AC surge suppression:
|
480 joules
|
AC suppression response time:
|
Instantaneous
|
EMI / RFI AC noise suppression:
|
Yes
|
PHYSICAL | |
Shipping weight (lbs):
|
48
|
Shipping weight (kg):
|
21.8
|
Unit weight (lbs):
|
44.6
|
Unit weight (kg):
|
20.2
|
Unit Dimensions (HWD/in):
|
12.75 x 7.5 x 9
|
Unit Dimensions (HWD/cm):
|
32.4 x 19.1 x 22.9
|
Material of construction:
|
PVC
|
Form factors supported:
|
Tower
|
Cooling method:
|
Cooling via rear-exit cooling fan
|
Battery Access:
|
Battery access door allows hot swap battery
replacement without powering connected equipment off
|
ENVIRONMENTAL | |
Operating Temperature:
|
+32 to +104 degrees Fahrenheit
0 to +40 degrees Celsius |
Storage Temperature:
|
+5 to +122 degrees Fahrenheit
-15 to +50 degrees Celsius |
Relative Humidity:
|
0 to 95%, non-condensing
|
COMMUNICATIONS | |
Network monitoring port:
|
Includes 2 built-in monitoring ports, 1-USB
& 1-RS232
|
Software and cabling included:
|
PowerAlert UPS monitoring software is available
via free download from www.tripplite.com for all common network and
standalone operating systems. Ships with 2 cables, 1-USB to USB &
1-DB9 to DB9
|
LINE / BATTERY TRANSFER | |
Transfer time from line power to
battery mode:
|
2-4 milliseconds
|
Low voltage transfer to battery power:
|
81V (resets to line power as voltage increases
to 85V)
|
High voltage transfer to battery power:
|
143V (resets to line power as voltage decreases
to 139V)
|
CERTIFICATIONS | |
Certifications:
|
UL1778 (USA, Series AGSM700PSR3HG), UL2601-1
(Medical), cUL (Canada), FCC Class A (emissions)
|
WARRANTY | |
Optional coverage:
|
3 year, 5 year, next day and on-site warranty
coverage available in many areas - contact Tripp Lite
|
Product warranty:
|
2 year product warranty
|
SPECIAL FEATURES | |
Cold Start:
|
Yes, inverter can be "cold started" to enable
temporary AC output during a power failure
|
Appearance:
|
Attractive gray tower UPS
|